Worksheet 4 - Option Configuration Guide - Toshiba STRATA DK14 Installation And Maintenance Manual

Worksheet 4 – Option Configuration Guide
Number
Option
Required
RRCS PCB
RRCS-4
RRCS-8
RRCS-12
RKYS1, 2, or 3
PIOU/RSIU
Subassembly
PCBs
IMDU PCB
RMDS PCB
RSIS
HESC-65A
HESB Amplifier/
Speaker
PPTC/PPTC9
Adapter (Modular
to RS-232)
PPTC
(25-pin)
PPTC-9
(9-pin)
Strata DK I&M 6/00
An RRCS (-4, -8 or 12 DTMF receiver circuits) must be installed on the RCTUA,
RCTUB, RCTUBA/BB, RCTUC/D, or RCTUE/F if the customer has: DTMF DID,
Tie, ANI, DNIS, DISA lines (remote change of call forward destination), DNIS
External Call Routing, using DTMF standard telephones, or voice mail-type
devices with DTMF interfaces
...or if the customer has built-in AA connected to RDSU, RSTU, RSTU2, PSTU, or
PESU standard telephone ports.
Both the RCTUC/D and RCTUE/F can support one RRCS on each PCB, 2
RRCSs total (maximum 24 DTMF receivers). For normal traffic, an RRCS-4 is
sufficient. However, for extremely high traffic, use an RRCS-8, -12, or multiple
RRCSs for large systems.
If built-in AA ACD, or ACD/MIS is required, one RKYS option key is required see
Table 4-18.
One IMDU PCB may be installed on the PIOU or PIOUS PCB to provide built-in
remote maintenance modem capability for the Strata DK system.
One RMDS PCB may be installed on the RSIU PCB to provide built-in remote
maintenance modem for the Strata DK424 system.
Up to three RSIS PCBs may be installed on the RSIU PCB to provide one or more
of the following RS-232 interface ports: MIS for ACD, SMDR, SMDI, and/or Local
Maintenance (TTY) Port for DKi Admin/Backup PC.
One HESC-65A modular connecting cable is required to connect the HESB to the
HHEU in each digital telephone and 6500-series electronic telephone requiring
the Loud Ringing Bell option.
One HESB is required for each digital and electronic telephone providing the Loud
Ringing Bell option.
One HESB is optional to provide single-zone external page connected to either a
PIOU, PIOUS, or PEPU (customer-supplied amplifiers/speakers may be used in
place of the HESB).
One HESB is optional to provide a talkback amplifier/page speaker connected to a
PIOU, PIOUS, or PEPU (a customer-supplied talkback amplifier/page speaker
may be used in place of HESB).
PPTC adapter is used to connect an external modem DB25 female connector to a
PIOU/ PIOUS/RSIU/RSIS modular jack. If a PPTC is used, a null modem adapter
is also required.
PPTC9 adapter is used to connect a personal computer DB9 male COM port
connector to a PIOU/PIOUS/RSIU/RSIS modular jack. These adaptors are
required for: SMIS for ACD, SMDI, SMDR, and system maintenance PC or
terminal interface.
Worksheet 4 – Option Configuration Guide
Comments
DK424 Configuration
4-31