Rddu Installation - Toshiba STRATA CTX100 Installation And Maintenance Manual

RDDU – Direct Inward Dialing Line Interface Unit
Circuits per PCB:
Interfaces with:
Older Version(s):
The RDDU provides four Direct Inward Dialing (DID) lines, each of which can have a single
office code along with a block of extensions.
Each extension can be assigned to ring a station [DN] that appears on one or multiple stations,
Distributed Hunt or ACD Group, or an external telephone number selected in system
programming. This enables calls over the same line to be routed to different stations or groups of
stations. An extension can also be assigned to ring the maintenance modem. Each RDDU can be
set for either wink start or immediate. All RDDU lines support DNIS and ANI features.
RDDU controls, indicators, and interface connectors are shown in
Table 4-10.

RDDU Installation

Note Switches are factory-set to the 0 (0 dB signal level drop) position.
1. If the KSU is located within one mile of the PBX or CO, set dB Pad switches SW101 through
SW401 to the 3 (-3 dB signal level drop) position to control excessive loudness resulting from
close proximity to the PBX or CO.
2. Sensitivity jumpers P101~P401 are used mostly for dial pulse operation, to adjust for dial
pulsing at different loop lengths. If close to the central office, the sensitivity should be set for
low (L); as the loop length increases, it should be set to medium (M), then high (H).
3. Insert the RDDU (component side facing right) into the appropriate slot and apply firm, even
pressure to ensure proper mating of connectors.
4. After installing the RDDU, gently pull the PCB outward. If the connectors are properly mated,
a slight resistance is felt.
Strata CTX I&M 10/02
four DID lines
DID (one or two-way) lines
none
RDDU – Direct Inward Dialing Line Interface Unit
Figure 4-18 and described in
PCB Installation
4-23