Chapter 39 Lldp-Med Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 39 LLDP-MED Command List

config lldp_med fast_start repeat_count <value 1 - 10>
config lldp_med log state [enable | disable]
config lldp_med notification topo_change ports [<portlist> | all] state [enable | disable]
config lldp_med ports [<portlist> | all] med_transmit_capabilities [all | {capabilities | network_policy | power_pse |
inventory}(1)] state [enable | disable]
show lldp_med ports {<portlist>}
show lldp_med
show lldp_med local_ports {<portlist>}
show lldp_med remote_ports {<portlist>}
39-1 config lldp_med fast_start repeat_count
Description
This command is used to configure the fast start repeat count. When an LLDP-MED Capabilities TLV is detected
for an MSAP identifier not associated with an existing LLDP remote system MIB, the application layer shall start
the fast start mechanism and set the 'medFastStart' timer to 'medFastStartRepeatCount' times 1.
Format
config lldp_med fast_start repeat_count <value 1 - 10>
Parameters
<value 1-10> - Enter a fast start repeat count value between 1 and 10. The default value is 4.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a LLDP-MED fast start repeat count of 5:
DGS-1510-28XMP/ME:admin#config lldp_med fast_start repeat_count 5
Command: config lldp_med fast_start repeat_count 5
Success.
DGS-1510-28XMP/ME:admin#
39-2 config lldp_med log state
Description
This command is used to configure the log state of LLDP-MED events.
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
333