D-Link DGS-1510/ME Series Reference Manual page 619

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Example
To configure the traffic log state on the Switch:
DGS-1510-28XMP/ME:admin# config traffic control log state enable
Command: config traffic control log state enable
Success.
DGS-1510-28XMP/ME:admin#
76-5 config traffic control auto_recover_time
Description
This command is used to configure the traffic auto recover time that allowed for a port to recover from shutdown
forever status.
Format
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
Parameters
auto_recover_time - Specifies the time allowed for auto-recovery from shutting down a port. The default value is
0, so no auto recovery is possible; the port remains in shutdown forever mode. This requires manual entry of
the config ports [ <portlist> | all ] state enable command to return the port to a forwarding state. The default
value is 0, which means disable auto recover mode, shutdown forever.
<min 0> - Enter 0 to disable the auto recovery time.
<min 1-65535> - Enter the auto recovery time value here. This value must be between 1 and 65535.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the auto recover time to 5 minutes:
DGS-1510-28XMP/ME:admin# config traffic control auto_recover_time 5
Command: config traffic control auto_recover_time 5
Success.
DGS-1510-28XMP/ME:admin#
615