D-Link DGS-1510/ME Series Reference Manual page 295

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
DGS-1510-28XMP/ME:admin#show address_binding dhcp_snoop binding_entry
Command: show address_binding dhcp_snoop binding_entry
S (Status) - A: Active, I: Inactive
Time - Left Time (sec)
IP Address
--------------------------------------- ----------------- -- ---------- -----
Total Entries : 0
DGS-1510-28XMP/ME:admin#
32-14 config address_binding dhcp_snoop max_entry ports
Description
This command is used to specify the maximum number of entries that can be learned by a specified port.
Format
config address_binding dhcp_snoop max_entry ports [<portlist> | all] limit [<value 1-50> | no_limit]
Parameters
<portlist> - Enter the list of ports used here.
all - Specifies that all the ports will be used.
limit - Specifies the maximum number. The default value is no_limit.
<value 1-50> - Enter the limit value here. This value must be between 1 and 50.
no_limit - Specifies that the maximum number of learned entries is unlimited.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set the maximum number of DHCP IPv4 snooping entries that ports 1–3 can learn up to 10 entries:
DGS-1510-28XMP/ME:admin# config address_binding dhcp_snoop max_entry ports 1-3 limit 10.
Command: config address_binding dhcp_snoop max_entry ports 1-3 limit 10.
Success.
DGS-1510-28XMP/ME:admin#
32-15 enable address_binding trap_log
Description
This command is used to send traps and logs when the IMPB module detects an illegal IP and MAC address.
MAC Address S
291
LT(sec) Port