Chapter 76 Traffic Control Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 76 Traffic Control Command List

config traffic control [<portlist> | all] {broadcast [enable | disable] | multicast [enable | disable] |unicast [enable |
disable] | action [drop | shutdown] | threshold <value 0-255000> | countdown [<min 0> | <min 3-30> | disable]
| time_interval <sec 5-600>}
config traffic trap [none | storm_occurred | storm_cleared | both]
show traffic control {<portlist>}
config traffic control log state [enable | disable]
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
76-1 config traffic control
Description
This command is used to configure broadcast/ multicast/ unicast packet storm control. Shutdown mode is provided
to monitor the traffic rate in addition to the storm control drop mode. If traffic rate is too high, this port will be shut
down.
Format
config traffic control [<portlist> | all] {broadcast [enable | disable] | multicast [enable | disable] | unicast
[enable | disable] | action [drop | shutdown] | threshold <value 0-255000> | countdown [<min 0> | <min 3-
30> | disable] | time_interval <sec 5-600>}
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specifies that all the ports will be used for this configuration.
broadcast - (Optional) Specifies to enable or disable broadcast storm control.
enable - Specifies that broadcast storm control will be enabled.
disable - Specifies that broadcast storm control will be disabled.
multicast - (Optional) Specifies to enable or disable multicast storm control.
enable - Specifies that multicast storm control will be enabled.
disable - Specifies that multicast storm control will be disabled.
unicast - (Optional) Specifies to enable or disable unknown packet storm control. ( Supported for drop mode
only)
enable - Specifies that unicast storm control will be enabled.
disable - Specifies that unicast storm control will be disabled.
action - (Optional) Specifies for storm control action, shutdown or drop mode. Shutdown mode is a function of
software, drop mode is implemented by the chip. If shutdown mode is specified, it is necessary to configure
values for the countdown and time_interval parameters.
drop - Specifies that the action applied will be drop mode.
shutdown - Specifies that the action applied will be shutdown mode.
threshold - (Optional) Specifies the upper threshold, at which point the specified storm control is triggered.
<value 0-255000> - Enter the upper threshold value here. This is the number of broadcast/multicast packets
per second received by the Switch that will trigger the storm traffic control measure. The threshold is
expressed as PPS (packets per second) and must be an unsigned integer. This value must be between 0
and 255000.
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
611