D-Link DGS-1510/ME Series Reference Manual page 91

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
hours - Specifies the time of a day.
start_time - Specifies the starting time of a day.
<time hh:mm:ss> - Enter the starting time here. (24-hr time). For example, 19:00 means 7PM. 19 is also
acceptable. The time specified in the start_time parameter must be smaller than the time specified in the
end_time parameter.
end_time - Specifies the ending time of a day. (24-hr time)
<time hh:mm:ss> - Enter the ending time here. (24-hr time). For example, 19:00 means 7PM. 19 is also
acceptable. The time specified in the start_time parameter must be smaller than the time specified in the
end_time parameter.
weekdays - Specifies the list of days contained in the time range. Use a dash to define a period of days. Use a
comma to separate specific days.
<daylist> - Enter the weekdays that will be included in this configuration here. For example, mon-fri
(Monday to Friday). sun, mon, fri (Sunday, Monday and Friday)
delete - Deletes a time range profile. When a time_range profile has been associated with ACL entries, deleting
the time_range profile will fail.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a time range named "1" that starts every Monday at 01:01:01am and ends at 02:02:02am:
DGS-1510-28XMP/ME:admin# config time_range 1 hours start_time 1:1:1 end_time 2:2:2 weekdays
mon
Command: config time_range 1 hours start_time 1:1:1 end_time 2:2:2 weekdays mon
Success.
DGS-1510-28XMP/ME:admin#
6-8 show time_range
Description
This command is used to display the current time range settings.
Format
show time_range
Parameters
None.
Restrictions
None.
Example
To display the current time range settings:
87