D-Link DGS-1510/ME Series Reference Manual page 517

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
DGS-1510-28XMP/ME:admin# show acct_client
Command: show acct_client
radiusAcctClient ==>
radiusAcctClientInvalidServerAddresses
radiusAcctClientIdentifier
radiusAuthServerEntry ==>
radiusAccServerIndex : 1
radiusAccServerAddress
radiusAccClientServerPortNumber
radiusAccClientRoundTripTime
radiusAccClientRequests
radiusAccClientRetransmissions
radiusAccClientResponses
radiusAccClientMalformedResponses
radiusAccClientBadAuthenticators
radiusAccClientPendingRequests
radiusAccClientTimeouts
radiusAccClientUnknownTypes
radiusAccClientPacketsDropped
DGS-1510-28XMP/ME:admin#
61-10 config accounting service
Description
This command is used to configure the state of the specified RADIUS accounting service.
Format
config accounting service [network | shell | system] state [enable | disable]
Parameters
network - Accounting service for 802.1X port access control. By default, the service is disabled.
shell - Accounting service for shell events: When user logs on or out the Switch (via the console, Telnet, or SSH)
and timeout occurs, accounting information will be collected and sent to RADIUS server. By default, the
service is disabled.
system - Accounting service for system events: reset, reboot. By default, the service is disabled.
state - Specifies the state of the specified service.
enable - Specifies to enable the specified accounting service.
disable - Specifies to disable the specified accounting service.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
0
0.0.0.0
0
0
0
0
0
0
0
0
0
0
0
513