D-Link DGS-1510/ME Series Reference Manual page 67

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Format
config authen server_group [tacacs | xtacacs | tacacs+ | radius | <string 15>] [add | delete] server_host
<ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
Parameters
tacacs - Specifies to configure built-in server group TACACS.
xtacacs - Specifies to configure built-in server group XTACACS.
tacacs+ - Specifies to configure built-in server group TACACS+.
radius - Specifies to configure built-in server group RADIUS.
<string 15> - Enter the server group name here. This value can be up to 15 characters long.
add - Specifies to add a server host to a server group.
delete - Specifies to remove a server host from a server group.
server_host - Specifies the server host's IP address.
<ipaddr> - Enter the server host IP address here.
protocol - Specifies the authentication protocol used.
tacacs - Specifies that the TACACS authentication protocol will be used.
xtacacs - Specifies that the XTACACS authentication protocol will be used.
tacacs+ - Specifies that the TACACS+ authentication protocol will be used.
radius - Specifies that the radius authentication protocol will be used.
Restrictions
Only Administrators can issue this command.
Example
To add an authentication server host to an server group:
DGS-1510-28XMP/ME:admin# config authen server_group mix_1 add server_host 10.1.1.222 protocol
tacacs+
Command: config authen server_group mix_1 add server_host 10.1.1.222 protocol ta
cacs+
Success.
DGS-1510-28XMP/ME:admin#
5-18 delete authen server_group
Description
This command is used to delete a user-defined authentication server group.
Format
delete authen server_group <string 15>
63