D-Link DGS-1510/ME Series Reference Manual page 613

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
75-2 traceroute6
Description
This command is used to trace the IPv6 routed path between the Switch and a destination end station.
Format
traceroute6 <ipv6addr> {ttl <value 1-60> | port <value 30000-64900> | timeout <sec 1-65535> | probe <value
1-9>}
Parameters
<ipv6addr> - Enter the IPv6 address of the destination end station.
ttl - (Optional) Specifies the time to live value of the trace route request. This is the maximum number of routers
that a trace route packet can pass. The traceroute6 command will cross while seeking the network path
between two devices. The range for the TTL is 1 to 60 hops.
<value 1-60> - Enter the time to live value here. This value must be between 1 and 60.
port - (Optional) Specifies the port number. The value range is from 30000 to 64900.
<value 30000-64900> - Enter the port number here. This value must be between 30000 and 64900.
timeout - (Optional) Specifies the timeout period while waiting for a response from the remote device. A value of
1 to 65535 seconds can be specified. The default is 5 seconds.
<sec 1-65535> - Enter the timeout period value here. This value must be between 1 and 65535 seconds.
probe - (Optional) Specifies the number of probing. The range is from 1 to 9. If unspecified, the default value is 1.
<value 1-9> - Enter the probing number value here. This value must be between 1 and 9.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Trace the IPv6 routed path between the Switch and 3000::1:
DGS-1510-28XMP/ME:admin# traceroute6 3000::1 probe 3
Command: traceroute6 3000::1 probe 3
1 <10 ms. 1345:142::11
2 <10 ms. 2011:14::100
3 <10 ms. 3000::1
Trace complete.
DGS-1510-28XMP/ME:admin#
Trace the IPv6 routed path between the Switch and 1210:100::11 with port 40000:
609