Chapter 37 Link Aggregation Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 37 Link Aggregation Command List

create link_aggregation group_id <value> {type [lacp | static]}
delete link_aggregation group_id <value>
config link_aggregation group_id <value> {master_port <port> | ports <portlist> | state [enable | disable]
config link_aggregation algorithm [mac_source | mac_destination|mac_source_dest | ip_source |
ip_destination | ip_source_dest]
show link_aggregation {group_id <value> | algorithm}
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
37-1 create link_aggregation group_id
Description
This command is used to create a link aggregation group on the Switch.
Format
create link_aggregation group_id <value> {type [lacp | static]}
Parameters
<value > - Enter the group ID value here.
type - (Optional) Specifies the group type is belong to static or LACP. If type is not specified, the default is static
type.
lacp - Specifies to use LACP as the group type.
static - Specifies to use static as the group type.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create link aggregation group:
DGS-1510-28XMP/ME:admin# create link_aggregation group_id 1 type lacp
Command: create link_aggregation group_id 1 type lacp
Success.
DGS-1510-28XMP/ME:admin#
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
308