Administrating The Dwr-500; Command Line Interface Access; Ip Based Access - D-Link DWR-500 Quick Installation Manual

Administrating the DWR-500

Command Line Interface Access

Console connection to the DWR-500 is the most
reliable means to gain access and configure the
DWR-500. Locate the five pin console cable terminal
and uncap the connector protector on the DWR-500.
Connect the five pin Ethernet cable to the DWR-500
console port as shown in Figure 22. Connect the
other end of the console cable to a laptop. To start
the Command Line Interface (CLI), configure your
terminal to the following settings as shown in Table
4. The login details are in Table 5.
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
Table 4. Terminal setting

IP Based Access

The DWR-500 default IP address is 192.168.0.1, with subnet mask of 255.255.255.0 on port 0. To access
the DWR-500 administration, set the connecting computer to a static IP address in the same subnet.
To connect via SSH to DWR-500 using the default IP
address as shown in Figure 23, supply the login
details as shown in Table 5.
Terminal Account
Terminal Password
Table 5. Terminal Login details
DWR-500 Quick Installation Guide
Figure 21. Installing the Feeder
115200
8
None
1
None
root
dlink
Figure 22. Connect console cable to DWR-500
DWR-500 login: root
Password: dlink
Hello, Welcome to D-Link CLI
Copyright 2006 D-Link Corporation
DWR-500> enable
DWR-500#
Figure 23. Terminal login session
10
.