Chapter 27 Filter Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 27 Filter Command List

config filter netbios [<portlist> | all] state [enable | disable]
show filter netbios
config filter extensive_netbios [<portlist> | all] state [enable | disable]
show filter extensive_netbios
27-1 config filter netbios
Description
This command is used to configure the Switch to deny the NetBIOS packets on specific ports.
Format
config filter netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Specifies the list of ports used.
all - Specifies that all the ports will be used for the configuration.
state- Specifies the state of the filter to block the NETBIOS packet.
enable - Specifies that the state will be enabled.
disable - Specifies that the state will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure filter NetBIOS state:
DGS-1510-28XMP/ME:admin# config filter netbios 1-10 state enable
Command: config filter netbios 1-10 state enable
Success.
DGS-1510-28XMP/ME:admin#
27-2 show filter netbios
Description
This command is used to display the NetBIOS filter state on the Switch.
Format
show filter netbios
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
227