D-Link DGS-1510/ME Series Reference Manual page 588

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
severity - (Optional) Specifies the severity level.
emergency - Severity level 0
alert - Severity level 1
critical - Severity level 2
error - Severity level 3
warning - Severity level 4
notice - Severity level 5
informational - Severity level 6
debug - Severity level 7
<level 0-7> - Enter the severity level value here. This value must be between 0 and 7.
facility - (Optional) Some of the operating system daemons and processes have been assigned Facility values.
Processes and daemons that have not been explicitly assigned a Facility may use any of the "local use"
facilities or they may use the "user-level" Facility. Those Facilities that have been designated are shown below.
This facility setting will be put in the syslog packet when it is sent to a specific syslog server.
local0 - Specifies that the user-defined facility will be set to local 0.
local1 - Specifies that the user-defined facility will be set to local 1.
local2 - Specifies that the user-defined facility will be set to local 2.
local3 - Specifies that the user-defined facility will be set to local 3.
local4 - Specifies that the user-defined facility will be set to local 4.
local5 - Specifies that the user-defined facility will be set to local 5.
local6 - Specifies that the user-defined facility will be set to local 6.
local7 - Specifies that the user-defined facility will be set to local 7.
udp_port - (Optional) Specifies the UDP port number.
<udp_port_number> - Enter the UDP port number used here.
ipaddress - (Optional) Specifies IP address for the host.
<ipaddr> - Enter the IP address used for the configuration here.
state - (Optional) Specifies the syslog protocol is used for the transmission of event notification messages across
networks to a host. The option enables or disables the host to receive such messages.
enable - Specifies that the host to receive such messages will be enabled.
disable - Specifies that the host to receive such messages will be disabled.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the syslog host configuration:
DGS-1510-28XMP/ME:admin# config syslog host all severity debug facility local0
Command: config syslog host all severity debug facility local0
Success.
DGS-1510-28XMP/ME:admin#
70-9 delete syslog host
Description
This command is used to delete the syslog host(s).
584