D-Link DGS-1510/ME Series Reference Manual page 327

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
DGS-1510-28XMP/ME:admin# show lldp
Command: show lldp
LLDP System Information
Chassis ID Subtype
Chassis ID
System Name
System Description
System Capabilities
LLDP Configurations
LLDP Status
LLDP Forward Status
Message TX Interval
Message TX Hold Multiplier: 4
ReInit Delay
TX Delay
Notification Interval
DGS-1510-28XMP/ME:admin#
38-8 show lldp mgt_addr
Description
This command is used to display the LLDP management address information.
Format
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
Parameters
ipv4 - (Optional) Specifies the IPv4 address used for the display.
<ipaddr> - Enter the IPv4 address used for this configuration here.
ipv6 - (Optional) Specifies the IPv6 address used for the display.
<ipv6addr> - Enter the IPv6 address used for this configuration here.
Restrictions
None.
Example
To display management address information:
: MAC Address
: 00-01-02-03-04-00
:
: Fast Ethernet Switch
: Repeater, Bridge
: Enabled
: Enabled
: 30
: 2
: 2
: 10
323