Chapter 30 Gratuitous Arp Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 30 Gratuitous ARP Command List

config gratuitous_arp send ipif_status_up [enable | disable]
config gratuitous_arp send dup_ip_detected [enable | disable]
config gratuitous_arp learning [enable | disable]
config gratuitous_arp send periodically ipif <ipif_name 12> interval <value 0-65535>
enable gratuitous_arp {ipif <ipif_name 12>} {trap | log}(1)
disable gratuitous_arp {ipif <ipif_name 12>} {trap | log}(1)
show gratuitous_arp {ipif <ipif_name 12>}
30-1 config gratuitous_arp send ipif_status_up
Description
The command is used to enable/disable sending of gratuitous ARP request packet while IPIF interface become up.
This is used to automatically announce the interface's IP address to other nodes. By default, the state is enabled,
and only one gratuitous ARP packet will be broadcast.
Format
config gratuitous_arp send ipif_status_up [enable | disable]
Parameters
enable - Specifies to enable sending of gratuitous ARP when IPIF status become up.
disable - Specifies to disable sending of gratuitous ARP when IPIF status become up.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable send gratuitous ARP request in normal situation:
DGS-1510-28XMP/ME:admin# config gratuitous_arp send ipif_status_up enable
Command: config gratuitous_arp send ipif_status_up enable
Success.
DGS-1510-28XMP/ME:admin#
30-2 config gratuitous_arp send dup_ip_detected
Description
The command is used to enable/disable sending of gratuitous ARP request packet while duplicate IP is detected.
By default, the state is enabled. For this command, the duplicate IP detected means that the system received an
ARP request packet that is sent by an IP address that matches the system's own IP address. In this case, the
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
249