D-Link DGS-1510/ME Series Reference Manual page 179

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
18-3 debug output
Description
This command is used to set a specified module's debug message output to debug buffer or local console. If the
user uses the command in a Telnet session, the error message also is output to the local console.
Format
debug output [module <module_list> | all] [buffer | console]
Parameters
module - Specifies the module list.
<module_list> - Enter the module list here.
all - Specifies to control output method of all modules.
buffer - Specifies to direct the debug message of the module output to debug buffer. This is the default option.
console - Specifies to direct the debug message of the module output to local console.
Restrictions
Only Administrators can issue this command.
Example
To set all module debug message outputs to local console:
DGS-1510-28XMP/ME:admin# debug output all console
Command: debug output all console
Success.
DGS-1510-28XMP/ME:admin#
18-4 debug config error_reboot
Description
This command is used to set if the Switch needs to be rebooted when a fatal error occurs. When the error occurs,
the watchdog timer will be disabled by the system first, and then all debug information will be saved in NVRAM. If
the error_reboot is enabled, the watchdog shall be enabled after all information is stored into NVRAM.
Format
debug config error_reboot [enable | disable]
Parameters
enable - Specifies to reboot when a fatal error happens.
disable - Specifies that the Switch will not reboot when a fatal error happens, system will hang-up for debug and
enter the debug shell mode for debug.
175