Chapter 32 Ip-Mac-Port Binding (Impb) Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 32 IP-MAC-Port Binding (IMPB)
create address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports [<portlist> | all]}
config address_binding ip_mac ports [<portlist> | all] {arp_inspection [strict | loose | disable] | ip_inspection
[enable | disable] | protocol [ipv4] | allow_zeroip [enable | disable] | forward_dhcppkt [enable | disable] |
stop_learning_threshold <int 0-500>}
delete address_binding blocked [all | vlan_name <vlan_name> mac_address <macaddr>]
delete address_binding ip_mac [all | ipaddress <ipaddr> mac_address <macaddr>]
config address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports [<portlist> | all]}
show address_binding {ports {<portlist>}}
show address_binding blocked [all | vlan_name <vlan_name> mac_address <macaddr>]
show address_binding ip_mac [all | [[ipaddress <ipaddr>] mac_address <macaddr>]]
show address_binding {[ip_mac [all | [[ipaddress <ipaddr>] [mac_address <macaddr>]] | blocked [all |
vlan_name <vlan_name> mac_address <macaddr>] | ports {<portlist>}]}
enable address_binding dhcp_snoop
disable address_binding dhcp_snoop
clear address_binding dhcp_snoop binding_entry ports [<portlist> | all]
show address_binding dhcp_snoop {max_entry {ports <portlist>}}
show address_binding dhcp_snoop binding_entry {port <port>}
config address_binding dhcp_snoop max_entry ports [<portlist> | all] limit [<value 1-50> | no_limit]
enable address_binding trap_log
disable address_binding trap_log
config address_binding recover_learning ports [<portlist> | all]
debug address_binding [event | dhcp | all] state [enable | disable]
no debug address_binding
32-1 create address_binding ip_mac ipaddress
Description
This command is used to create an IMPB entry.
Format
create address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports [<portlist> | all]}
Parameters
<ipaddr> - Enter the IP address used for the IMPB entry.
mac_address - Specifies the MAC address used for the IMPB entry.
<macaddr> - Enter the MAC address used here.
ports - (Optional) Specifies the portlist the entry will apply to. If not ports are specified, the settings will be applied
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Command List
280