D-Link DGS-1510/ME Series Reference Manual page 297

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
32-17 config address_binding recover_learning ports
Description
This command is used to recover IMPB checking.
Format
config address_binding recover_learning ports [<portlist> | all]
Parameters
<portlist> - Enter the list of ports that need to recover the IMPB checking.
all - Specifies that all the ports will be used.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To recover IMPB checking for ports 6 to 7:
DGS-1510-28XMP/ME:admin# config address_binding recover_learning ports 6-7
Command: config address_binding recover_learning ports 6-7
Success.
DGS-1510-28XMP/ME:admin#
32-18 debug address_binding
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet or a DHCP
packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]
Parameters
event - Specifies to print out the debug messages when IMPB module receives ARP/IP packets.
dhcp - Specifies to print out the debug messages when the IMPB module receives the DHCP packets.
all - Specifies to print out all debug messages.
state - Specifies the IMPB debug state to be enabled or disabled.
enable - Specifies to enable the IMPB debug state.
disable - Specifies to disable the IMPB debug state.
293