Removing A Usb Embedded Hypervisor Flash Device - Lenovo System x3250 M5 Installation And Service Manual

What to do next
1. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
2. Reconnect the power cords and any cables that you removed.
3. Turn on the peripheral devices and the server.

Removing a USB embedded hypervisor flash device

Use this information to remove a USB embedded hypervisor flash device.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are replacing a server component in the server, you need to slide the server out from the rack
enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.
To remove a hypervisor flash device, complete the following steps.
Step 1. Remove the cover (see "Removing the cover" on page 157).
Step 2. Remove the PCI riser-card assembly (see "Removing the PCI riser-card assembly" on page 163).
Step 3. Locate the USB embedded hypervisor flash device connector on the system board.
Figure 127. Location of the USB embedded hypervisor flash device connector
Step 4. Slide the lockbar on the flash device connector to the unlocked position and pull the USB flash
device out of the connector.
198
Lenovo System x3250 M5Installation and Service Guide