SAS/SATA power
connector
SAS/SATA power cable
Figure 139. 4 x 3.5-inch simple-swap backplate assembly cable connection
Step 4.
Reinstall the hard disk drives and filler panels (see "Replacing simple-swap hard disk drives" on
page 138).
Step 5.
Reinstall the cover (see "Replacing the cover" on page 120).
Step 6.
Slide the server into the rack.
Step 7.
Reconnect the power cords and any cables that you removed.
Step 8.
Turn on the peripheral devices and the server.
Removing a USB embedded hypervisor flash device
Use this information to remove a USB embedded hypervisor flash device.
To remove a USB hypervisor flash device, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the cover (see "Removing the cover" on page 119).
Step 4.
Grasp the flash device and pull to remove it from the connector.
SAS/SATA signal
cable
.
Chapter 5
Removing and replacing components
221