Installing A Hot-Swap Power Supply - Lenovo System x3250 M5 Installation And Service Manual

Figure 65. USB embedded hypervisor flash device installation
Step 6. Reinstall the PCI riser-card assembly (see "Replacing the PCI riser-card assembly" on page 78).
If you have other devices to install, do so now. Otherwise, go to "Completing the installation" on page 78.

Installing a hot-swap power supply

Use this information to install a hot-swap power supply.
The following notes describe the type of power supply that the server supports and other information that
you must consider when you install a power supply:
• Depending on your server model, the server comes standard with one 460-watt hot-swap power supply.
For redundancy support, you must install an additional hot-swap power supply, if one is not installed in
your model.
• Make sure that the devices that you are installing are supported. For a list of supported optional devices
for the server, see http://www.lenovo.com/us/en/serverproven/.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power
72
Lenovo System x3250 M5Installation and Service Guide