Lenovo System x3250 M5 Installation And Service Manual page 64

Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
To install a hot-swap SAS or SATA hard disk drive, complete the following steps:
Note: If you have only one hard disk drive, you must install it in the left drive bay.
Attention: To avoid damage to the hard disk drive connectors, make sure that the server cover is in place
and fully closed whenever you install or remove a hard disk drive.
Step 1. Remove the filler panel from the empty drive bay. Keep the filler panel in a safe place.
Step 2. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
Step 3. Install the hard disk drive in the drive bay:
a. Make sure that the tray handle is in the open (unlocked) position.
b. Align the drive with the guide rails in the bay.
Figure 43. 2.5-inch hot-swap hard disk drive installation
Figure 44. 3.5-inch hot-swap hard disk drive installation
50
Lenovo System x3250 M5Installation and Service Guide