Figure 86. Cover installation
Step 3.
Make sure that the cover correctly engages all the inset tabs on the server.
Step 4.
Slide the server all the way into the rack until the server locks into place with an audible click.
Step 5.
Reconnect the power cords and all external cables, and turn on the server and peripheral devices.
Step 6.
Check the "Server controls, LEDs, and power" on page 14.
Removing the air baffle
Use this information to remove the air baffle from the server.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are replacing a server component or installing an optional device in the server, you need to slide the
server out from the rack enclosure, turn off the server and peripheral devices, and disconnect the power
cords and all external cables.
To remove the air baffle, complete the following steps.
Step 1.
Remove the cover (see "Removing the cover" on page 157).
Step 2.
Place your fingers under the front and back of the top of the air baffle; then, lift the air baffle
out of the server.
.
Chapter 6
Removing and replacing server components
159