Table of Contents
Advertisement
8x1.8-inch
drive backplane
assembly
1.8-inch
filler panel
Figure 185. Backplane assembly installation
Step 5.
Slide the drive backplane assembly into the slot until it clicks into place.
Step 6.
Connect the combination power/configuration cable to the connectors on the backplane assembly;
then connect the signal cables to the backplane assembly (as shown in the illustration).
Note: You can reconnect the cables to the drive backplane before installing the backplane onto the
cage or you can connect the cables after you install the backplane, if that is easier for you.
Step 7.
Reinstall the drives that you removed from the old assembly into the new drive backplane assembly
(see "Replacing a hot-swap drive" on page 211).
Step 8.
Install the drive filler panel.
Step 9.
Install the cover (see "Replacing the cover" on page 196).
Step 10. Slide the server into the rack.
Step 11. Reconnect the power cords and any cables that you removed.
Step 12. Turn on the peripheral devices and the server.
Removing a USB embedded hypervisor flash device
Use this information to remove a USB embedded hypervisor flash device.
To remove a USB hypervisor flash device, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the cover (see "Removing the cover" on page 195).
Step 4.
Remove the flash device:
264
Lenovo System x3650 M4 HD Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
