Removing A Usb Embedded Hypervisor Flash Device - Lenovo System x3650 M5 Installation And Service Manual

10. Replace the fan cage assembly and fans if you removed them (see "Replacing
11. Install the top cover (see "Replacing the top cover" on page 148).
12. Slide the server into the rack.
13. Reconnect the power cords and any cables that you removed.
14. Turn on the peripheral devices and the server.

Removing a USB embedded hypervisor flash device

Use this information to remove a USB embedded hypervisor flash device.
About this task
To remove a USB hypervisor flash device, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page v and "Installation
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the top cover (see "Removing the top cover" on page 147).
4. Remove the flash device:
Figure 198. USB hypervisor flash device removal
250
Lenovo System x3650 M5 Type 5462: Installation and Service Guide
9. Reinstall the hard disk drives and filler panels (see "Replacing a simple-swap
hard disk drive" on page 159).
the fan cage assembly" on page 176 and "Replacing a hot-swap fan" on page
178).
guidelines" on page 294.
Lockbar
a. Unlock the retention latch on the USB connector by pushing down the blue
locking collar.
b. Grasp the flash device and pull to remove it from the connector.
USB embedded
hypervisor
flash device