Lenovo System x3250 M5 Installation And Service Manual page 393

1. Check the LEDs for both power supplies.
2. Follow the actions in Power-supply LEDs.
• 806f0007-0301ffff : [ProcessorElementName] has Failed with IERR. (CPU 1)
This message is for the use case when an implementation has detected a Processor Failed - IERR
Condition.
May also be shown as 806f00070301ffff or 0x806f00070301ffff
Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - CPU
SNMP Trap ID
40
CIM Information
Prefix: PLAT ID: 0042
User Response
1. Make sure that the latest level of firmware and device drivers are installed for all adapters and
standard devices, such as Ethernet, SCSI, and SAS. Important: Some cluster solutions require
specific code levels or coordinated code updates. If the device is part of a cluster solution, verify
that the latest level of code is supported for the cluster solution before you update the code.
2. Update the firmware (UEFI and IMM) to the latest level (Updating the firmware).
3. Run the DSA program.
4. Reseat the adapter.
5. Replace the adapter.
6. (Trained technician only) Replace microprocessor n.
7. (Trained technician only) Replace the system board. (n = microprocessor number)
• 806f0008-0a01ffff : [PowerSupplyElementName] has been added to container
[PhysicalPackageElementName]. (Power Supply 1)
This message is for the use case when an implementation has detected a Power Supply has been added.
May also be shown as 806f00080a01ffff or 0x806f00080a01ffff
Severity
Appendix A. Integrated Management Module II (IMM2) error messages
379