Removing The Bezel - Lenovo System x3250 M5 Installation And Service Manual

Figure 88. Air baffle installation
Step 2. Reinstall the cover (see "Replacing the cover" on page 158).
What to do next
1. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
2. Reconnect the power cords and any cables that you removed.
3. Turn on the peripheral devices and the server.

Removing the bezel

Use this information to remove the bezel.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are replacing a server component in the server, you need to slide the server out from the rack
enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.
To remove the bezel, complete the following steps.
Step 1. If the server has been installed in a rack, press the two release latches on the front of the server
and remove the server out of the rack enclosure.
Attention: Two or more people are required to remove the server from a rack cabinet.
Step 2. Remove the drives and drive bay filler panels from the drive bays (see "Removing a hot-swap hard
disk drive" on page 172, or "Removing a simple-swap hard disk drive" on page 175, or "Removing
the optional DVD drive" on page 179).
Step 3. Remove the screws from the bezel.
.
Chapter 6 Removing and replacing server components
161