Installing The 2.5-Inch Hot-Swap Hard Disk Drive Backplane (4 To 8 Hard Disk Drive Upgrade) - Lenovo System x3250 M5 Installation And Service Manual

Figure 33. 3.5-inch simple-swap hard disk drive with ServeRAID SAS/SATA controller cable connection
(hardware RAID card inserted on the right side)
Step 6. Make sure the relevant cables pass through the cable clips.
Step 7. Reinstall the PCI riser-card assembly if applicable (see "Replacing the PCI riser-card assembly" on
page 78).
If you have other devices to install, do so now. Otherwise, go to "Completing the installation" on page 78.
Installing the 2.5-inch hot-swap hard disk drive backplane (4 to 8 hard
disk drive upgrade)
Use this information to install the 2.5-inch hot-swap hard disk drive backplane (4 to 8 hard disk drive
upgrade).
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are installing an optional device in the server, you need to slide the server out from the rack enclosure,
turn off the server and peripheral devices, and disconnect the power cords and all external cables.
The following diagram shows the 2.5-inch hot-swap hard disk drive four to eight upgrade kit contents:
44
Lenovo System x3250 M5Installation and Service Guide