Replacing The Bezel - Lenovo System x3250 M5 Installation And Service Manual

Figure 89. Bezel removal
Step 4. Pull the top of the bezel out slightly; then, rotate it downward until the tabs on the bottom of the
bezel disengages from the chassis and set it aside.
If you are instructed to return the server component or optional device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.

Replacing the bezel

Use this information to replace the bezel.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are replacing a server component in the server, you need to slide the server out from the rack
enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.
To replace the bezel, complete the following steps.
Step 1. Insert the tabs on the bottom of the bezel into the holes on the chassis.
Step 2. Rotate the bezel upward to the server and reinstall the bezel screws.
Figure 90. Bezel installation
Step 3. Reinstall the drives and drive bay filler panels into the drive bays (see "Replacing a hot-swap hard
disk drive" on page 174, or "Replacing a simple-swap hard disk drive" on page 177, or "Replacing
the optional DVD drive" on page 179).
Step 4. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
162
Lenovo System x3250 M5Installation and Service Guide