Installing The 3.5-Inch Simple-Swap Hard Disk Drive Backplate Assembly - Lenovo System x3250 M5 Installation And Service Manual

Figure 28. 2.5-inch simple-swap hard disk drive with ServeRAID SAS/SATA controller cable connection
(hardware RAID card inserted on the right side)
Step 6. Make sure the relevant cables pass through the cable clips.
Step 7. Reinstall the PCI riser-card assembly if applicable (see "Replacing the PCI riser-card assembly" on
page 78).
If you have other devices to install, do so now. Otherwise, go to "Completing the installation" on page 78.

Installing the 3.5-inch simple-swap hard disk drive backplate assembly

Use this information to install the 3.5-inch simple-swap hard disk drive backplate assembly.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are installing an optional device in the server, you need to slide the server out from the rack enclosure,
turn off the server and peripheral devices, and disconnect the power cords and all external cables.
There are two types of 3.5-inch simple-swap hard disk drive backplate assemblies:
40
Lenovo System x3250 M5Installation and Service Guide