Figure 163. Software RAID signal cable routing for redundant power supply
Step 4.
Lift the backplate out of the server.
Step 5.
Slide the replacement backplate into the guide channels, making sure that any nearby wires or
cables are not trapped or pinched.
Step 6.
Replace the backplate assembly (see "Replacing the 2.5-inch simple-swap hard disk drive
backplate assembly" on page 227 or "Replacing the 3.5-inch simple-swap hard disk drive
backplate assembly" on page 232).
Step 7.
Connect the respective signal and power cables of the replacement backplate to the hardware
RAID card and power supply (fixed or redundant).
Note: Make sure the relevant cables pass through the cable clips.
.
Chapter 6
Removing and replacing server components
235