Lenovo System x3250 M5 Installation And Service Manual page 117

Where:
imm_internal_ip
The IMM2 internal LAN/USB IP address. The default value is 169.254.95.118.
imm_user_id
The IMM2account (1 of 12 accounts). The default value is USERID.
imm_password
The IMM2 account password (1 of 12 accounts). The default value is PASSW0RD (with
a zero 0 not an O).
Note: If you do not specify any of these parameters, ASU will use the default values. When the
default values are used and ASU is unable to access the IMM2 using the online authenticated
LAN access method, ASU will automatically use the unauthenticated KCS access method.
The following commands are examples of using the userid and password default values and
not using the default values:
Example that does not use the userid and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoUUID <uuid_value> –user <user_id>
–password <password>
Example that does use the userid and password default values:
asu set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
• Online KCS access (unauthenticated and user restricted):Online KCS access (unauthenticated
and user restricted):
You do not need to specify a value for access_method when you use this access method.
Example:
asu set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
The KCS access method uses the IPMI/KCS interface. This method requires that the IPMI driver
be installed. Some operating systems have the IPMI driver installed by default. ASU provides
the corresponding mapping layer. See the Advanced Settings Utility Users Guide for more
details. You can access the ASU Users Guide from the Lenovo website.
Note: Changes are made periodically to the Lenovo website. The actual procedure might vary
slightly from what is described in this document.
1. Go to http://www.lenovo.com/support.
2. Click on the Downloads tab at the top of the panel.
3. Under ToolsCenter, select View ToolsCenter downloads.
4. Select Advanced Settings Utility (ASU).
5. Scroll down and click on the link and download the ASU version for your operating system.
Scroll down and look under Online Help to download the Advanced Settings Utility Users
Guide.
• Remote LAN access, type the command::
Note: When using the remote LAN access method to access IMM2 using the LAN from a client,
the host and the imm_external_ip address are required parameters.
host <imm_external_ip> [user <imm_user_id>][password <imm_password>]
Where:
imm_external_ip
The external IMM2 LAN IP address. There is no default value. This parameter is required.
imm_user_id
.
Chapter 3 Configuration information and instructions
103