Replacing The Power Paddle Card - Lenovo System x3250 M5 Installation And Service Manual

Replacing the power paddle card

Use this information to replace the power paddle card.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are replacing a server component in the server, you need to slide the server out from the rack
enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.
To replace the power paddle card, complete the following steps.
Step 1. Align the power paddle card with the standoffs on the system board and lower the power paddle
card onto the system board until it is secure.
Figure 181. Power paddle card installation
Step 2. Reinstall the safety cover (see "Replacing the 240 VA safety cover" on page 247).
Step 3. Reconnect the power cable to the DVD power cable (if available).
Step 4. Reconnect the cables to the hard disk drive backplane or the backplate assembly.
Step 5. Reconnect the power cables to power connectors on the system board.
252
Lenovo System x3250 M5Installation and Service Guide