Lenovo System x3250 M5 Installation And Service Manual page 105

– Legacy Support
Select this choice to view or set legacy support.
– Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does not support UEFI video
output standards.
– Rehook INT 19h
Select this choice to enable or disable devices from taking control of the boot process. The default
is Disable.
– Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass storage devices that are
non-UEFI compliant. The default is Enable.
– Infinite Boot Retry
Select this choice to enable or disable UEFI to infinitely retry the legacy boot order. The default
is Disable.
– BBS Boot
Select this choice to enable or disable legacy boot in BBS manner. The default is Enable.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM) support.
– Integrated Management Module II (IMM2)
Select this choice to view or change the settings for the Integrated Management Module II (IMM2).
– Power Restore Policy
Select this choice to set the mode of operation after the power lost.
– Commands on USB Interface
Select this choice to enable or disable the Ethernet over USB interface on IMM2. The default
is Enable.
– Network Configuration
Select this choice to view the system management network interface port, the IMM2 MAC address,
the current IMM2 IP address, and host name; define the static IMM2 IP address, subnet mask, and
gateway address, specify whether to use the static IP address or have DHCP assign the IMM2 IP
address, save the network changes, and reset the IMM2.
– Reset IMM2 to Defaults
Select this choice to view or reset IMM2 to the default settings.
– Reset IMM2
Select this choice to reset IMM2.
– Recovery
Select this choice to view or change the system recovery parameters.
– POST Attempts
Select this choice to view or change the number of attempts to POST.
• POST Attempts Limit
Select this choice to view or change the Nx boot failure parameters.
– System Recovery
Select this choice to view or change system recovery settings.
.
Chapter 3 Configuration information and instructions
91