Lenovo System x3250 M5 Installation And Service Manual page 50

Figure 24. 2.5-inch simple-swap hard disk drive backplate assemblies
To install the 2.5-inch simple-swap hard disk drive backplate assembly, complete the following steps:
Step 1. Remove the cover (see "Removing the cover" on page 33).
Step 2. Remove the PCI riser-card assembly if applicable (see "Removing the PCI riser-card assembly" on
page 163).
Step 3. Align the backplate assembly with the backplate assembly alignment slots in the chassis.
Step 4. Lower the backplate assembly into the slot in the chassis until the front tab clicks into the latches
on the chassis.
36
Lenovo System x3250 M5Installation and Service Guide