Internal Cable Routing And Connectors - Lenovo System x3250 M5 Installation And Service Manual

Hide thumbs Also See for System x3250 M5:

Table of Contents

Reconnect the external cables and power cords; then, turn on the attached devices and turn on

Step 10. Start the Setup utility and reset the configuration.

Set the system date and time.

Set the power-on password.

Reconfigure the server.

See "Using the Setup utility" on page 89 for details.

Step 11. Either update the server with the latest RAID firmware or restore the pre-existing firmware from a

diskette or CD image.

Step 12. Update the UUID (see "Updating the Universal Unique Identifier (UUID)" on page 102).

Step 13. Update the DMI/SMBIOS (see "Updating the DMI/SMBIOS data" on page 104).

Step 14. Reactivate any Features on Demand features.

Internal cable routing and connectors

This section provides information about routing the cables when you install some components in the server.

For more information about the requirements for cables and connecting devices, see the documentation

that comes with these devices.

Cabling the DVD drive

The internal routing and connectors for the DVD drive.

1. To disconnect the optional optical drive cable, you must first press the connector release tab, and

then disconnect the cable from the connector on the system board. Do not disconnect the cable by

using excessive force.

2. Follow the optical drive cable routing as the illustration shows. Make sure that the cable is not pinched

and does not cover any connectors or obstruct any components on the system board.

3. Make sure the relevant cables pass through the cable clips.

Removing and replacing server components