Removing A Usb Embedded Hypervisor Flash Device - Lenovo x3650 M4 BD 5466 Installation And Service Manual

Figure 116. Cable routing
Attention:
• Make sure the relevant cables pass through the cable clips.
• Make sure that the cable is not pinched and does not cover any connectors or obstruct any
components on the system board.
Step 5. Install the server top cover (see "Replacing the server top cover" on page 248).
Step 6. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices
and the server.

Removing a USB embedded hypervisor flash device

Use this information to remove a USB embedded hypervisor flash device.
To remove a USB hypervisor key from the server, complete the following steps:
Step 1. Read the safety information that begins on page "Safety" on page v and "Installation guidelines"
on page 30.
Step 2. Turn off the server (see "Turning off the server" on page 19) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. Remove the server top cover (see "Removing the server top cover" on page 247).
Step 4. Rotate the hot-swap rear hard disk drive cage up (see "Rotating the hot-swap rear hard disk
drive cage up" on page 155.
188
Lenovo System x3650 M4 BDInstallation and Service Guide