Lenovo System x3250 M5 Installation And Service Manual page 241

Step 7. Lift the blue tab on the backplate assembly to disengage and remove the backplate assembly
from the chassis.
Figure 154. 2.5-inch simple-swap hard disk drive backplate assembly removal
If you are instructed to return the server component or optional device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Replacing the 2.5-inch simple-swap hard disk drive backplate assembly
Use this information to replace the 2.5-inch simple-swap hard disk drive backplate assembly.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are replacing a server component in the server, you need to slide the server out from the rack
enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.
To replace the 2.5-inch simple-swap hard disk drive backplate assembly, complete the following steps:
Step 1. Align the backplate assembly with the backplate assembly alignment slots in the chassis.
Step 2. Lower the backplate assembly into the slot in the chassis until the front tab clicks into the latches
on the chassis.
.
Chapter 6 Removing and replacing server components
227