Figure 109. DVD drive installation
If you have replaced a server component or installed an optional device in the server, you need reinstall
the cover, slide the server into the rack, reconnect the power cords and all external cables, and turn on the
server and peripheral devices.
Removing the DVD drive cable
Use this information to remove the DVD drive cable.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are replacing a server component in the server, you need to slide the server out from the rack
enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.
To remove the DVD drive cable, complete the following steps:
Step 1.
Remove the cover (see "Removing the cover" on page 157).
Step 2.
Remove the DVD drive bay filler panel from the server.
Step 3.
Disconnect the DVD drive cable from the system board.
Attention: Do not disconnect the DVD drive cable by using excessive force.
.
Chapter 6
Removing and replacing server components
181