Lenovo System x3250 M5 Installation And Service Manual page 247

Figure 161. 3.5-inch simple-swap hard disk drive backplate assembly installation
Step 4. Connect the cables to the RAID adapter or system board (see "Internal cable routing and
connectors" on page 259).
Step 5. Reconnect the power cable.
Step 6. Make sure the relevant cables pass through the cable clips.
Step 7. Reinstall the hard disk drives and filler panels (see "Replacing a simple-swap hard disk drive" on
page 177).
Step 8. Reinstall the PCI riser-card assembly if applicable (see "Replacing the PCI riser-card assembly" on
page 163).
Step 9. Reinstall the cover (see "Replacing the cover" on page 158).
What to do next
1. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
2. Reconnect the power cords and any cables that you removed.
3. Turn on the peripheral devices and the server.
Replacing software RAID simple-swap hard disk drive backplate with hardware RAID
simple-swap hard disk drive backplate
Use this information to replace software RAID simple-swap hard disk drive backplate with hardware RAID
simple-swap hard disk drive backplate.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 31.
If you are replacing a server component in the server, you need to slide the server out from the rack
enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.
To replace the software RAID simple-swap hard disk drive backplate with hardware RAID simple-swap hard
disk drive backplate, complete the following steps:
.
Chapter 6 Removing and replacing server components
233