Breaker/Power Switch (On/Off); Control Panel (Rear Of Projector) - Christie Roadie HD+35K Setup Manual

Section 3: Operation

3.1.2 Breaker/Power Switch (ON/OFF)

The breaker/power switch on the ballast serves two purposes:
1) It is a breaker/power switch for the Roadie HD+35K ballast.
2) It protects against over-current conditions of 50A or more.
The breaker/power switch must be ON in order to enable normal Roadie HD+35K system power-up and
operation. If faulty or major excessive AC is detected, the breaker "trips" to OFF in order to prevent damage.
Try switching the breaker/power switch ON again. If the breaker/power switch continues to trip OFF, this
indicates a major fault, and the AC problem must be resolved. Possible causes might include shorts, damage to
lamp cables, or very excessive AC.
You must press POWER on the built-in keypad as this breaker/power switch does not power up the
NOTE:
projector or start the lamp.
The ballast's internal fan indicates whether or not the breaker/power switch is ON. There is no other indicator.
Lights on the ballast indicate only that the ballast is plugged in.

3.1.3 Control Panel (Rear of Projector)

The rear control panel includes the built-in keypad, IR sensor, 2-digit status/error code display window, and the
LCD status display, as described in
Table 3.1 Rear Projector Control Panel
Control Panel Area
Built-In Keypad
IR Sensor
Two-Digit Status/Error
Code Window
LCD Status Display
3-2
Table 3.1.
LCD Status Display Window
On/Off
Status/Error Code Display
Figure 3-2 Rear Control Panel
Provides access to all software controls needed for working with the projector. For
more convenient functionality, you can use a remote, web browser, or a serial message-
based method of control.
Sensors at the front and rear of the projector detect commands from the standard IR
remote.
The code that displays in this window indicates the basic operational state of the
projector. Each code references its corresponding status/error message and displays it
in the LCD Status Display window. See Section 3.4.1 System Warnings/Errors.
Full status and error messages appear in this window.
Status info and error
messages appear here
Auto Input 1
Menu
Setup
BNC
Lens Input 3
Focus Zoom Help
Shift
Video
Input 5
Shutter Exit
Opt.1
Description
IR Sensor
Input 2
DVI
Input 4
S-Vid
Input 6
Opt. 2
Built-in Keypad
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)