Connect “Projector” Breaker Power Cables To Projection Head - Christie CP2000 User Manual

INSTALLATION AND SETUP
2-6
the IEC receptacles located near Panel B (100-230 VAC) and Panel C
(200-230 VAC). These cables are interchangeable—connect either cable to
either receptacle, and secure with metal strain-relief clip provided. See
Figure 2.7. NOTE: For CP2000-S Models – Refer to the Addendum for
Installation and Use provided.
Figure 2.7. Connect "Projector" Breaker Power Cables to Projection Head
IMPORTANT: Components in the lamp compartment will require 200-230
VAC.
NOTE: If you prefer to use an uninterruptible power supply (UPS) for supplying
power to the projection head, route the UPS power cables through the pedestal toe
and connect to the IEC receptacles on Panel B (100-230 VAC). In this case, only one
power cable provided in the pedestal is used.
5-6) CHECK DEDICATED OUTLET:
supplies for the Ethernet hub and TPC both connect to the single internal
outlet at the front pedestal corner known as the "dedicated" outlet (Figure
2.8). No other components or external equipment should be connected
here. NOTES: 1) This is a current-limited 120 VAC outlet powered by the
ballast and separately fused. 2) Refer to the separate CP2000-S Addendum
for power connection details.
(CP2000 shown)
Within the pedestal, confirm that the power
LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)