Ral-Remote Access Level; Rbt-Reboot; Sdi-Sdi Payload Overrride - Christie Mirage SST Technical Reference

RAL–Remote Access Level
Sets the default remote serial protocol access level for any of the serial ports.
Commands
Command Description
RAL <value> Sets the access level on all Ethernet port.
(Saved value)
RAL+PRTA <value> Sets the access level for the RS232 port.
(Saved value)
Examples
Set port to Login Required:
(RAL+PRTA 1)
RBT–Reboot
Reboots the projector.
This command only works if the projector is in standby mode.
Commands
Command Description
RBT 111 Reboots the projector. To prevent accidental
use of this command, the number 111 must
follow this command.
Examples
Reboot the projector:
(RBT 111)
SDI–SDI Payload Overrride
Overrides the SMPTE 352M payload for HBMIC-SDI inputs.
This setting applies to all HBMIC-SDI inputs in the system (such as, not per input).
Mirage SST Technical Reference–Serial Commands
020-103005-03 Rev. 1 (01-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Serial API commands
Values
0 = No Access—Disables the port
1 = Login Required—Sets read-only access
until a separate login is performed
2 = Free Access—Executes commands at
the operator level unless a separate login is
performed (Default)
Values
111
51