Standard Ir Remote And Transmission; Wired Ir Remote - Christie Roadie HD+35K Setup Manual

Section 3: Operation

3.2.2 Standard IR Remote and Transmission

The Roadie HD+35K comes with a standard IR remote which controls the projector by way of wireless
communication from a battery-powered infrared (IR) transmitter. Use the standard IR remote the same way
you would use any remote supplied with a TV or DVD player.
When pressing any key, ensure that you direct the remote either toward the screen or toward the front or rear of
the projector. One of the two IR sensors on the projector detects the signals and relays the commands for
internal processing.
See the key descriptions provided for the standard IR remote

3.2.3 Wired IR Remote

Should you require a wired connection, use the cable (100 ft. cable supplied) to connect to the 3-pin XLR jack
connector (Figure
settings accordingly. The wired standard IR remote is recommended when:
• The rear built-in keypad is inaccessible
• The lighting conditions are unsuitable for proper IR transmission
3-4
3-3) located at the rear of the projector. You also need to set the proper internal jumper
Figure 3-3 Standard IR Remote Keypad
(Figure 3-3).
Roadie HD+35K Setup Guide
020-100394-06 Rev. 1 (10-2013)