Honda 2010 CRF250R Service Manual page 130

FUEL SYSTEM (PGM -FI)
5-34
3. Make sure the connection is secure and that the
pawls are firmly locked into place: check visually and
by pulling the connector.
4. Make sure the rubber cover is in place (between the
quick connect fitting and fuel pump plale).
5. Install the quick connect filling caver securely.
Set the rubber cover tab into the quick connect fitting
cover groove.
6 . Increase the fuel pressure and check thai there is no
leakage in fuel supply system (page 3-6).
INJECTOR SIDE
1. Insert a new retainer into the connector.
NOTE:
Align new retainer locking pawls with the connector
grooves.
2. Set a new joint rubber to the injector joint as shown.
3. Install the connector to the injector joint by aligning
retainer tabs wi th joint rubber grooves.
Then press the quick connect fitting onto the injector
joint until both retainer locking pawls lock with a
"CLICK".
If it is hard to connect, put a small amount of engine
oil on the injector joint end.
CONNECTOR
RUBBER COVER
RUBBER COVER
CONNECTOR
JOINT RUBBER
s.9
JOINT
FITTING COVER
Align
TAB
GROOVE
RETAINER
~.,
....
CONNECTOR