Condenser Removal/Installation; Condenser Inspection - Honda 2010 CRF250R Service Manual

ELECTRICAL SYSTEM
CONDENSER
Select the
kD
rBnge
of the tester.
16-16
REMOVALIINSTALLA TION
Disconnect the condenser 2P (Black) connector.
Remove the condenser from the regulatorlrectifier stay.
Installation is in the reverse order of removal.
INSPECTION
Connect a 12 V battery to the fuel pump sub harness r-""...~~. ~~---,---------
(page 5-12). wire side/male terminal
Disconnect the condenser 2P (Black) connector.
I
Turn the "ECM" selector switch ON.
Measure and record the vol tage at the condenser 2P 81 G
(Black) connector terminals of the wire side.
Connection : Black
(+) -
Green
H
STANDARD : About battery voltage
If there is no voltage, check for open circui t in Black or
Green wires.
If there is voltage, check the condenser as follows.
e
1. Turn the "ECM" selector switch OFF and connect
I]:€i~~~~~~~;=,--- ___ --===~
the condenser 2P (Black) connector.
r
2. Turn the "ECM" selector switch ON for a few
seconds and charge the condenser.
3. Turn the "ECM" selector switch OFF and discharge
the condenser.
4. Disconnect the condenser 2P (Black) connector and
check the resistance between the condenser side
terminals.
I:~"_
The condenser is normal
jf
the resistance comes
near
00
once and eventually becomes
0:) •
If the resistance stays al 00 or does not change,
wire side/female terminal
e
replace the condenser.
If the inspection is interrupted, connect the
~:€]~~~~~~~~
________
J
condenser 2P (Black) connector and restart the
procedure from the slep 1.