Fork Damper Disassembly - Honda 2010 CRF250R Service Manual

FRONT WHEEL/SUSPENSION/STEERING
FORK DAMPER DISASSEMBLY
'10:
Set the fork damper in a vise with a piece of wood or ,--- - - - - - - - - - - - - - - - -,
soft jaws to avoid damage. FORK CAP BOLT HOLDER FORK DAMPER
Hold the fork damper using the special 1001.
TOOL:
Lock nut wrench , 50 mm
07WMA·KZ30100
Loosen the fork cap assembly using the special 1001
while holding the fork damper.
TOOL:
Fork cap boll holder, 36 mm
NOTE:
070MB·MEN01QO or
070MB·MENA100
(U .S.A. only)
Check the lock nut installation . If the lock nut was
removed , the piston rod will fall into the fork damper and
you will not be able to reassemble the fork damper.
After '10:
Set the fork damper in a vise with a piece of wood or
,-------r
soft jaws to avoid damage.
Hold the fork damper using the special tool.
TOOL:
Lock nut wrench, 50 mm 07WMA·KZ30100
Loosen the fork cap assembly while holding the fork
damper.
NOTE :
Check the lock nut installation. If the lock nut was
removed , the piston rod will fall into the fork damper
and you will not be able to reassemble the fork damper.
Remove the fork cap assembly from the fork damper
while pumping the piston rod slowly.
'10 shown :
FORK
13-19