Honda 2010 CRF250R Service Manual page 410

HYDRAULIC BRAKE
ASSEMBLY
BRACKET
BRAKE PAD RETAINER
5.4 N'm (0.6 kgf-m. 4.0 IbUt)
PINS ~
I
CALIPER PISTONS
$I
~
DUST SEAL
~ I
PISTON SEAL
CALIPER
"c
.
/ .
< ,-
PAD SPRING BRACKET PIN BOOT
Coat new piston seal lips with clean brake fluid.
Coat new dust sea! lips with silicon grease.
Install each pis/on
Inslall the piston and dust seals into the grooves in the
seal. dust seal and
caliper.
caliper piston in
their proper
locations.
Coat the caliper piston outer surfaces with clean brake
fluid and install them into the caliper cylinder with their
open ends facing the pad.
Install the brake pad retainer onto the caliper bracket.
Note the installation
Install the pad spring into the caliper.
direction of the pad
spring.
Replace the caliper and bracket pin boots
if
there is
wear. deterioration or damage.
Install the caliper pin boot and bracket pin boot.
Apply silicone grease to the caliper and bracket pins
sliding area .
When
assembling Assemble the caliper and bracket.
the caliper and
bracket. set the boot
into the
slide
pin
groove.
15·24
PISTON SEALS
1$1
~
P
DUST SEALS
II
CALIPER
!3:!-'
~
• PISTONS
""jill
RETAINER BOOTS
BRACKET
~ PINS
PAD