Honda 2010 CRF250R Service Manual page 340

FRONT WHEEUSUSPENSION/STEERING
When using /fie
special tool the
smaller outside
diameter must face
the bearing.
13-54
Install a new upper outer race, bearing race installers, UPPER OUTER RACE
~
and installer shaft as shown.
~~
Hold the shaft with a wrench, and turn the installer to
install the upper outer race.
TOOLS :
Bearing ra ce installer
(2 required)
Installer shaft
070MF·MEN0100
or
070MF·MENA100
(U .S.A. only)
07VMF· KZ30200
....
~~~~~ SH~A~F ~ T ~ ==================~
Temporarily install the steering stem nul onto the stem 1 '10 shown: STEERING STEM
to prevent the threads from being damaged when
removing the lower tapered roller bearing from the LOWER BEARINI3
steering stem.
Remove the lower tapered rolier bearing wi th a chisel or
equivalent lools, being careful not to damage the
steering slem.
Remove the dust seal.
STEM NUT DUST SEAL
Apply specified grease (page 1-19) to the lips of a new
r---~----:-~T''---''''----,
dust seal, and install it over the steering stem.
Install a new lower tapered roller bearing using a
hydraulic press and the special tool as shown.
TOOL:
Attachment, 30 mm I,D. 07746-0030300